Saturday, September 10, 2011

Niagara Cutter CD430 Carbide End Mill, General Purpose, TiN Coated, 4 Flutes, Double End, 3/8" Cutting Length, 1/8" Cutting Diameter

Niagara Cutter CD430 Carbide End Mill, General Purpose, TiN Coated, 4 Flutes, Double End, 3/8" Cutting Length, 1/8" Cutting Diameter Reviews



Other Picture


Niagara Cutter CD430 Carbide End Mill, General Purpose, TiN Coated, 4 Flutes, Double End, 3/8" Cutting Length, 1/8" Cutting Diameter Feature

  • Four flutes produce a better finish than fewer flutes
  • Double-end square nose end mills create sharp, unrounded cuts and have cutting edges on both ends for longer tool life
  • Titanium nitride (TiN) is a general-purpose coating that combines high-temperature resistance and increased hardness compared to uncoated end mills
  • Carbide can run at higher speeds than high-speed steel, resisting abrasion and high cutting temperatures
  • Center-cutting design allows the end mill to plunge into material like a drill bit while also performing conventional surface milling

The Niagara Cutter CD430 TiN-coated carbide double end square nose end mill has four flutes and a 30-degree helix angle for general-purpose machining on a range of materials. The double-end design has cutting edges on both ends, allowing a new cutting surface to be substituted when the first shows wear, which doubles the tool’s life compared to single-end square nose end mills. The tool’s square end has straight cutting edges that create sharp, unrounded cuts, and the center-cutting design has cutting teeth at the end of the tool, so it can be fed into the workpiece like a drill bit. Four flutes produce a better finish than fewer flutes. The 30-degree helix angle supports general-purpose applications. It balances lower angles’ strong cutting edge for difficult-to-machine materials with higher angles’ increased cutting action.

The general-purpose TiN coating combines stability at high temperatures with hardness for wear protection, increasing tool life and performance compared to uncoated end mills. (TiN is suitable for a range of materials, but TiCN or uncoated end mills are recommended for machining aluminum.) The carbide substrate is harder than high-speed or cobalt steel, making it more wear resistant at high speeds and providing longer tool life. Cutting diameter tolerance is +0.000” to -0.002”. The round shank accommodates a variety of holders.

End mills are designed to remove material and create multi-dimensional shapes and profiles. They have cutting edges along the outside diameter and flutes that remove chips from the cutting area and allow cooling fluids to enter. If heat is not reduced effectively, the tool’s cutting edges will dull and additional material buildup can occur. The number of flutes can range from two to eight. Two-flute designs offer the most efficient chip removal, but more flutes provide a smoother finish. The shank is the end of the tool held in place by a tool holder or machine. Center-cutting end mills can create three-dimensional shapes and profiles, and make plunge cuts similar to a drill bit. Non-center-cutting end mills are for applications such as peripheral milling and finishing, but cannot make plunge cuts.

Niagara Cutter has been designing and manufacturing precision cutting tools since 1954. Specializing in end mills, cutting mills, and saws, the company is based in New York and manufactures its tools at facilities in Pennsylvania and Massachusetts. This allows the company control over production, from substrate to coating, which is essential for customers in a variety of industries, especially aerospace and automotive.


Visit Store Now !!

Detail Products

Detail Reviews




No comments:

Post a Comment